2005 Ford Escape
Mileage
118,369
Service Date
8/19/2021
Services Performed
- CHECK ENGINE LIGHT IS ON. EXHAUST SMELL OUTSIDE OF THE VEHICLE. LEAKS OIL ABS LIGHT IS ON
- Scan and record codes located in vehicle systems. Perform diagnostic tests to determine cause of vehicle service light(s). P0430 BANK 2 CATALYST
- Inspect vehicle exterior lighting. Check under hood fluids and top off with manufacturer specified fluid(s). Check engine air filter and serpentine belt(s). Drain vehicle engine oil. Check tire pressure and fill to manufacturer's specifications. Perform visual inspection of the vehicle suspension and underbody. Check vehicle drivetrain fluids when needed. Fill engine with 6.0 quarts of Quaker State semi-synthetic engine oil. Recheck engine oil level.
- Remove and replace rear glass hinges. Test for proper operation
- Remove and replace B2 converter, B2S1 oxygen sensor, and B2S2 oxygen sensor, along with related exhaust gasket(s). Recheck for proper operation
- Remove and replace right front brake tone ring. Test for proper operation
- Remove the front brake rotors and clean the rotor mounting surfaces. Clean the caliper slides and lubricate. Reassemble the front brakes with new brake pads and brake rotors. Test drive for proper braking operation.
- Place vehicle on alignment rack, attach equipment, measure caster, camber and toe. Compare to vehicle specifications. Set and adjust all approved alignment angles with allowable specifications.
- Separate the lower control arm lower ball joint as need and unbolt the lower control arm assembly. Reassemble with new lower control arm as well as new bushings and lower ball joint assemblies if needed. Reassemble all other related components.
- Remove and replace front and rear brake hose assembly. Bleed air out of the brake system. Test drive for proper operation.
- Disassemble the subframe assembly and suspension required to access the transmission. Remove the transmission assembly. Remove and replace the rear main seal with housing. Reassemble all related components. Fill the transmission with manufacturers specified fluid. Test drive for proper operation.
- Disassemble the vehicle exhaust system and subframe assembly when needed to access the engine oil pan assembly. Remove the engine oil pan assembly. Clean the gasket surfaces. install the oil pan assembly with new gasket(s). Reassemble all related components with new gaskets when needed. recheck for leak(s).
- Remove the upper intake manifold assembly to access the lower intake. Remove the lower intake manifold. Clean all gasket surfaces and install the intake manifolds with new gaskets. Reassemble all related components. Fill with manufacturer specified fluids. Recheck for leak(s).
LAURIE S. gave our service a 5 star review on 8/24/2021
